These two guide channels on the back of the range. The back panel of backguard is positioned inside For sufficient load strength, YOU MUST attach two (2) screws through the back corners of the top down into the shell. for cooking tailored to your needs with a 24-inch Counter Depth Gas Range from Thermador. The Pot-and-Pan Shelf models require pre-assembly of the top panel to the shell using nine (9) of the enclosed Torx-head screws. Height: 3641 inches, up to 46 inches including a backguard. Using a T-20 size Torx driver, fasten the backguard with four (4) Torx-head screws to the range side panels. (Remove the griddle or grill assembly for sufficient installation clearance on these model ranges.) The backguard is inserted inside the guide channels on the back of the range, as shown in the illustration Figure 15. SEE RANGE INSTALLATION MANUAL.Īn Island Trim is available for covering the backguard area of the range for island installations however, the Island Trim can only be used where there is a minimum of 12” horizontal clearance between a combustible back wall and the back of the range. A Low Back or Pot-and-Pan Shelf must be installed when there is less than 12” clearance from a combustible back wall and the back of the range above the cooking surface. We carry kitchen products that include refrigerators, freezers, icemakers, wine coolers, cooktops, stoves, wall ovens, ranges, microwaves, hoods, dishwashers. The backguard must be attached before sliding the range into the final, installed position. See Chart C for the correct size of Backguard Kit to match the range. To avoid possible burn or fire hazard, a backguard designed specif- ically for this range must be installed whenever the range is used.ĭO NOT attempt to install a Thermador "GP" Series Backguard, which has air holes in the back panel to supply (only) one cooling fan.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |